Three findings from our FAA facility inspection, and what each one taught us

The FAA inspected our repair station on October 23, 2026. Four days later we had a list of three things to correct. None of them was about the shop floor.

Published .

What the inspectors looked at

The facility inspection is the fourth of the FAA’s five certification phases. By the time it happens, the certification team has accepted your manuals. The inspection checks that the shop matches them.

Inspectors from our local FAA office came on October 23. They asked for every manual, the capability list, the personnel roster and the calibration log. They walked the facility and looked at tools, calibration and how parts were segregated. Then they had us run one job through our own system, from work order to maintenance release, on our own forms.

They also reviewed our repairman applications. Each applicant needed a photo ID and sat for a short interview.

Finding 1: the training forms did not show who authorized the trainer

Our training forms did not document that the person giving the training had been authorized to give it.

The lesson is that a training record has to stand on its own. Someone reading it a year from now should be able to tell who was trained, by whom, and on whose authority, without asking anyone.

Finding 2: a tolerance with no source

One test in our manual gave a pass or fail tolerance and did not say which standard the number came from.

The quality control manual is supposed to refer, where it applies, to the manufacturer’s inspection standards (14 CFR 145.211). A number with no reference looks like a number the shop made up, even when it is correct. Every limit, tolerance and interval in a manual needs its source next to it.

Finding 3: the training program did not say how training is delivered

Our training program set out the initial and recurrent training. It did not state the delivery methods: whether a given subject is taught in a classroom session, on the job or by self-study, for example.

The training program is a document the FAA approves, under 14 CFR 145.163. If it doesn’t say how a course is delivered, a training record can’t be checked against it.

What the three have in common

All three were about what our documents said. Two of the three were about training paperwork, which is easy to treat as a formality.

We sent the corrections the day after the list arrived. The certificate followed eight days later.

  1. Facility inspection
  2. The inspectors send three items to correct
  3. We send the corrections
  4. Corrections accepted
  5. Certificate issued, 13 days after the inspection

Check your own shop before inspection day

  • Every training record shows who gave the training and who authorized them to give it.
  • The training program says how each subject is delivered.
  • Every limit, tolerance and interval in your manuals cites the standard or the manufacturer’s data it comes from.
  • The calibration log is current for every tool you use to decide airworthiness.
  • Every name on the roster has an employment summary behind it.
  • Every article on the capability list has a self-evaluation on file.
  • You can walk one job from work order to maintenance release on your own forms, with nothing missing.
  • Anyone applying for a repairman certificate has a photo ID with them.

That list is part of our pre-inspection, the visit we make to a client’s shop before the FAA does. It is included in our fixed fee.

This is one inspection, at one FAA office, in one year. Your inspectors will have their own list. The dates and findings are from our own file.

Tell us about your shop

A few questions about your shop. We read every message ourselves and reply by email. If we look like a fit, you get a written scope and price before any work starts.

Prefer email? hello@stationreadiness.com

For example: limited airframe, class 1 accessory, limited instrument.

Do you have a facility today?

We use what you send only to reply to you. How we handle it.